DOCUMENT

45 Cooker hoods from Miele Installation drawings DA 2660 1) Vent connection alternatively to rear DA 2690 1) Vent connection alternatively to rear DA 2690 EXT 1) Air extraction for 222 x 89 mm flat ducting can also be connected at the back and to the left DA 2620 1) Vent connection alternatively to rear DA 6890 1) When installing the fan, it can be turned. So exhaust air can be extracted upwards, left, right or downwards. The motor can also be fitted in the same position at the back of the appliance. If the motor is fitted at the back of the appliance, the back panel of the furniture housing unit must be cut out in the installation area and sufficient installation space must be provided behind the unit. 2) The electrical components can, if required, be positioned to the left of the fan inside the canopy or inside the wall unit. 3) Dimensions depend on material Installation with a gas hob is only possible with KM 2354G If the installation of an oven is planned in front of the appliance, relevant installation instructions and requirements regarding cooling air must be observed. DA 2906 1) Suction side 2) Fan, ducts upwards or to any side 3) Motor can be installed to suit. Ducting and connection cable required to link to appliance 4) Min. gap of 50 mm required for installation against a wall