DOCUMENT

Appliance door open angle The door hinges are set ex-works to enable the door to open to 115°. However, if the appliance door hits an adjacent wall when opened, for example, the opening angle can be limited to 90°. It is important when preparing the niche to ensure that you are aware of the door hinging requirements as some installation configurations based on the door hinging restrict other doors. Ventilation To prevent condensation build-up and potential damage to the appliance/s, it is advisable to install the appliance/s with sufficient ventilation in a dry and/or an air-conditioned room. Ensure that doors are closing and sealing properly and that the appliance/s are installed in accordance with the operating and installation instructions. The air vents must not be covered or blocked in any way. The air separator must also be fitted to separate air entering the appliance from that leaving it. This ensures efficient operation of the appliance. If the air separator is not fitted, warm air flowing into the appliance may cause overheating. As shown in installation diagrams, there is a minimum of 102 mm required between the floor and the base of the furniture door to ensure adequate ventilation. Adjusting the height of the appliance When adjusting the height of the appliance, care should be taken with the front and rear adjustments. Carefully tilt the appliance forward or backward to relieve the weight of the unit whilst adjusting the mechanism. Never raise or lower the unit without relieving the weight of the unit from the adjustment mechanisms. If the weight is not relieved adjustment mechanisms can become damaged, resulting in the appliances height not being adjustable. Additional accessories Please note that the MasterCool appliance does not come supplied with any side panels for side-by-side installation, handles or door panels. Select accessories are available from Miele if required, and must be ordered with the MasterCool appliance. Any affect on appliance performance caused by incorrect installation will not be covered by the manufacturers warranty.