DOCUMENT

Additional installation information Product weight All MasterCool appliances are very heavy and can tip forwards when the door is open. Keep the door shut until the appliance has been built in and secured within the building-in niche in accordance with the operating and installation instructions. Due to the size and weight of the appliance, installation must be carried out by two people (as a minimum, and will depend on the number of appliances being installed). Installation surface To ensure the safe installation of the appliance and to guarantee its correct functioning, the floor in the niche where the appliance is to be installed must be smooth and even. It must be made from strong, rigid material (Miele recommends that a concrete floor is the most suitable installation surface). The appliance is extremely heavy when fully loaded, and for this reason it is imperative that the floor it stands on is able to bear its weight. If necessary, the advice of an architect or structural engineer should be sought. Due to the significant weight and size of each MasterCool unit it is important to ensure that the floor is protected when moving appliances. Miele recommend MDF sheeting to prevent marking or damage to flooring such as wooden floor boards, tiles, etc. 10 amp L = 3 m L = 2 m Both the mains water and power connection must not be installed behind the MasterCool unit/s niche. Mains water connection Connection to the mains water supply should only be carried out by a qualified and competent person in accordance with national and local regulations. MasterCool appliances with automatic ice makers and/or water dispensers are only suitable for connection to a cold water supply. The maximum inlet water temperature should not exceed 40°C. The water pressure (flow rate) must be between 2.0 and 8.0 bar. If the supply water pressure is greater than 8.0 bar, make sure to install a pressure reducing valve to ensure 8.0 bar is not exceeded. Connection tomainswater supplymust incorporate a mains stopcock with ¾” thread. A tap must be provided between the supplied 2 m stainless steel hose and the household water supply to ensure that the water supply can be disconnected if necessary. The tap should be easily accessible after the appliance has been built in. Refer to installation instructions for position of water inlet hose on appliance. Under no circumstances should the tap be installed either behind the appliance or above the appliance to ensure accessibility to turn the tap off quickly if the need arises. Before use, the inlet pipe should be purged of air.